Command replace, between two fixtures.

    This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

    • Hi,
      backup your show first and then (if Replace command does not offer swopping fixtures at all) you can try:

      1. way: There was, I think, a command in gma2, I cannot find it in manual now, like Replace Fixture 1 Thru 2 With Fixture 2 Thru 1. This would swap data in between these 2 fixtures. Try it in dot2. If it fails then:

      2. way, keeping IDs: Patch the same fixturetype as your 2 fixtures are, set its ID to...1001. Clone Fixture 1 At 1001.
      Then normaly Replace Fixture 1 With Fixture 2.
      Then Clone Fixture 1001At Fixture 2.
      Then Delete Fixture 1001 in the patch.

      3. way, IDs change: Try to swop IDs in your patch in between those 2 fixtures. But it is only an idea, try it. But you may not like changing them.


      The post was edited 6 times, last by astandera ().